Cisco 2900 switch manual

Cisco IOS software version runn ing on the switch. The software version is on the Cisco IOS label on the switch rear panel. For translations of the warnings that appear in this pu blication, see the Regulatory Compliance and Safety Information for the Catalyst Switch guide. About This Guide. This section discusses the objectives, intended audience, and organization of the Catalyst User Guide, and defines the conventions used to convey instructions and information.. Cisco documentation and additional literature are available on a CD called Cisco Connection Documentation, Enterprise Series. CONTENTS CHAPTER 1 Product Overview 1 SwitchModels 1 FrontPanelComponents 3 10//Ports 4 PoEandPoE+Ports 4 MultigigabitEthernetPorts 5 ManagementPorts 5 USBTypeAPort 6 UplinkPorts 6 RearPanel 8 RFIDTag 9 StackWisePorts 9 PowerSupplyModules 9 FanModules 12 EthernetManagementPort 12 RJConsolePort 13 NetworkConfigurations .

Switch Features The XL switches are members of an extended network system of stackable, modular LAN and WAN products that increase LAN performance, connect remote offices and users, and provide secure access. Figure shows the five versions of the XL switch and lists their key features. Switches running standard software are designated by the letter A, and switches running Enterprise Edition Software are designated by the letters EN. Contents vi Catalyst Switch Software Configuration Guide OL Hostnames Passwords SNMP Community Strings TACACS+ and RADIUS LRE Profiles Using the CLI to Manage Switch Clusters Cisco IOS software version runn ing on the switch. The software version is on the Cisco IOS label on the switch rear panel. For translations of the warnings that appear in this pu blication, see the Regulatory Compliance and Safety Information for the Catalyst Switch guide.

Blinking LEDs indicate that the switch is already configured and cannot go into Express Setup mode. At step ➄, the switch port to connect an Ethernet cable is. Cisco 29Series Hardware Installation With the power switch on and the SYS LED on and green, does the fan operate? – If no, check the fan. Connect Switches and Hubs 1. Connect a Category 5 crossover cable (not supplied) to a 10/ port on the front panel of the switch. 2. Connect the other end.