Installing manual locking hubs

 · Step 1. Use a 9/inch hex bit to remove the six socket-head hub screws that hold the OEM manual locking hub’s cap in Step 2: Remove the cap to expose the locking hub assembly. Step 3: Use the blade of a small screwdriver to lift up the . Installing Manual Locking Hubs: 1. If replacing automatic locking hubs with manual locking hubs reinstall the axle shaft splined steel washer or needle thrust bearing and the axle retaining ring. 2. Install the Hublock assembly against the wheel hub and rotor. 3. Install the wheel and tire and torque the lug nuts to 85 to ft-lb. After removing the drive-flange, it's a simple task to put the new hubs on as well. Separate the cover plate from the hub body, and apply the liquid gasket-maker to the wheel flange and to the backside of the hub body. Let it gum up a minute or two, then press the two together and install the six bolts.

The new hub slides right on. The hubs came with some locking tabs but I ditched them in favor of some blue locktite instead. Don’t forget to install the rest of the allen head bolts on the chrome selector part of the hub. The hubs came with locking tabs for the bolts but as I said earlier, I ditched them for some blue locktite instead. This is a quick demonstration on how to install Warn Locking Hubs in Ford D Ford D GM Dana 60, and Dodg. an easy and simple improvement to the ford ranger. if I can do it, you can to - i'm 16 and the only other mechanical experience I have is a couple oil and fi.

14 thg 7, How to Install Manual Hubs on Vitara / Tracker · zip out the 10mm head bolts. · Once the bolts are out you can GENTLY tap around the edges with a. Before installing 4x4 locking hubs remove and discard the following. DRIVE FLANGE. MANUAL HUB. AUTO HUB. WARN AUTO HUB. NOTE: When removing MANUAL HUBS. 16 thg 8, So I took to searching a bit and didn't turn up anything. Can someone point me to a writeup on a warn locking hub installation how-to.